1) raw materials bake at a one-time: The reason is that the Dryer Machine is too small, and the raw material installed in the Dryer Machine too much, there may be wind network wind pressure and flowmeter is not correct, wrong; another reason is that Dryer Machine operators are not familiar with the Dryer Machine, resulting in improper use of the drying machine. For the first reason, you can change the Dryer Machine to a larger capacity, or can be loaded each time less, but also can increase the temperature of the Dryer Machine, but this method is easy to cause the Dryer Machine inside the fire, so you can change the Dryer Machine.
For the second and third reasons, you can contact the Dryer Machine manufacturers to solve, the former can require the Dryer Machine manufacturers to recalculate wind pressure, flow and then according to the actual situation to provide design change program; the latter can consult with the Dryer Machine manufacturer to obtain the equipment instructions to learn the correct way to make the Dryer Machine.
2) material wet and dry uneven, may be the use of drying equipment improper, it is also possible that the material of the Dryer Machine is affected by low temperature into a group-shaped.
For the former, we should strengthen the technical training of the operators, so that they can master the operation skills; if the raw material into a group, you need to break the drying materials, and then dry.
3) Dryer Machine does not take place: one reason is improper installation of Dryer Machine , air leakage or improper installation of the Dryer Machine; second reason is the design of the Dryer Machine, and the air pressure of the Dryer Machine is not enough. The solution to the former is to check whether the installation is correct with respect to the installation drawings and check whether there is a leak at the pipe interface and then solve it accordingly; the design problem of the Dryer Machine itself should be the responsibility of the Dryer Machine manufacturer.
4) Drying equipment wastes fuel: If the equipment is poor in heat insulation, it needs to improve its insulation performance. It can be covered with a layer of insulation material. If there is a problem with the design of the Dryer Machine or the design of the Dryer Machine stove, it is necessary to Contact the manufacturer to resolve.
5 Drying machine raw materials on fire: The raw material suction can lead to the drying machine inside the fire, but also may be Dryer Machine is too small to achieve drying effect and forced heating, causing fire, may be the use of Dryer Machine improper, and then Dryer Machine design principles are problematic. For the first reason, you should check that the Dryer Machine device is properly installed, whether air leakage or increase wind pressure; the second reason, you can change the Dryer Machine, you can also replace a large number of Dryer Machines; For operators do not understand, can be familiar with the Dryer Machine, and to learn the operation of the Dryer Machine note; it's a problem with the device itself,Manufacturers must be required to replace or retrofit repair Dryer Machines.
6 Drying Machine "shooting": This may be because the Dryer Machine temperature is too high, causing fire burning in the drying equipment, but also may be due to the Dryer Machine is blocked caused by the "shooting" phenomenon.
For the former, should reduce the Dryer Machine temperature, for the latter, should clean Dryer Machine, so that the machine to maintain smooth.